Embroidery stabilizer and needle guide by fabric
Use a 75/11 needle with standard 40 wt thread, and usually a cutaway stabilizer with more underlay on knits such as T-shirts and polos. Pick your fabric and thread below to see what else changes.
Knits with 40 wt (standard) thread
- Knits stretch. They need more underlay (the hidden stitches under the design).
- Fills that run across the knit's ribs, or tilted about 15 to 20 degrees off horizontal, hold better than fills that run along them.
- Always stitch a test on a scrap of the same fabric first. Every fabric pulls differently.
How to use it
- Choose the fabric you are stitching on.
- Choose the thread weight you are using.
- Follow the tips, and stitch a test on a scrap of the same fabric first.
What changes for each fabric
Woven fabric (twill, denim, canvas)
- Woven fabrics are the most forgiving.
Knits (T-shirts, polos)
- Usually a cutaway stabilizer.
- Knits stretch. They need more underlay (the hidden stitches under the design).
- Fills that run across the knit's ribs, or tilted about 15 to 20 degrees off horizontal, hold better than fills that run along them.
Sweatshirts and fleece (sweatshirts, hoodies, fleece)
- Sweatshirts and fleece need stronger underlay and a little more density than woven fabric.
Towels and other pile fabrics (towels, terry, other looped or pile fabrics)
- A water-soluble topping on top helps.
- A light base layer in the towel's color under small text and thin lines keeps them from sinking into the loops.
- Keep letters at least 0.4 in (10 mm) tall and lines at least 0.04 in (1 mm) wide.
- Large filled designs don't need the base layer.
Caps (baseball caps)
- Stitch from the center outward and from the bottom up, so the fabric is pushed toward the edges.
- Always use underlay, and make borders at least 0.08 in (2 mm) wide.
- Keep designs under about 2.25 in (57 mm) tall, and visors under about 1.5 in (38 mm).
Leather and vinyl (leather, faux leather, vinyl)
- Every needle hole is permanent. Use minimal underlay, lower density and a sharp needle.
3D puff foam (puff foam on caps and garments)
- No underlay under the puff, denser satin, and columns under about 0.28 in (7 mm) so the needle cuts the foam cleanly.
Questions
What stabilizer do I use for embroidery on a T-shirt?
Usually a cutaway stabilizer. T-shirts and polos are knits, which stretch, so they also need more underlay (the hidden stitches under the design).
What needle do I use for machine embroidery?
A 75/11 needle with standard 40 wt thread. Fine 60 wt thread uses a 65/9 or 70/10 needle, and heavier 30 wt thread an 80/12.
How do I embroider on a towel?
Put a light base layer in the towel's color under small text and thin lines so they don't sink into the loops. A water-soluble topping on top helps. Keep letters at least 0.4 in (10 mm) tall and lines at least 0.04 in (1 mm) wide.
What is different about embroidering caps?
Stitch from the center outward and from the bottom up, so the fabric is pushed toward the edges. Always use underlay, and make borders at least 0.08 in (2 mm) wide.
Can you embroider on leather?
Yes, with care: every needle hole is permanent. Use minimal underlay, lower density and a sharp needle, and test on a scrap first.